5.8GHz 25mW FPV 40CH Transmitter Description: The race band is a special frequency band with improved channel spacing. This wider channel spacing allows you to run multiple 25mW transmitters at the same time in proximity with each other. Perfect for racing with your buddies.
It is very easy to see and change the band and channel using the push button and LED.
The input voltage from 5V-20V.
You can power the transmitter directly from your 2S- 4S Lipo pack.
When the transmitter is powered from 7.0V and higher, it can provide 400mA @5V to power your camera. You can use this to charge a Gopro in-flight, or to power your micro CCD/CMOS camera.
There is a small solder jumper which you can remove to bypass the 5V regulator and feed the input voltage directly to your camera. This is useful if you are powering the transmitter with 12V and are using a 12V camera, too .
No heatsink is needed, the transmitter is barely warm.
A built in microphone is tuned for hearing your motor RPM’s in flight. It works very well with the Headplay Goggles, which have a built in speaker.
This latest generation transmitter can powered ON without an antenna connected, and will not be damaged by doing so.
For example,if you break your antenna in a crash- you will not burn out this video transmitter.
The video and power connector is locking, to prevent it from accidentally coming loose.
5.8GHz 25mW FPV 40CH Specifications:
- 40 channels
- SMA Antenna connector
- Dimensions: 31*22*10mm (not including SMA adapter)
- Voltage Input- 7-20V
Line 1: DC-IN (7-20V)
Line 2: GND
Line 3: VIDEO_IN
Line 4: GND
Line 5: 5V_OUT
Change frequency band and channel
Single push to change CH, push and hold for 2 seconds to change band.
Below is the channel table for your reference:
5.8GHz 25mW Transmitter Includes:
- 1 x 5.8GHz 25mW FPV Transmitter (40CH)
- 1 x 5.8GHz 3dBi Antenna SMA male
- 1 x harness for camera and JST female for power
- 1 x RG316 SMA female Pigtail to SMA male 10cm