Activity Stream

TBS is known to sell stuff at super-steep prices for people who do not want to dig deep. the current flying wing sells at 100$ plus, even though any...

I agree & I don't appreciate 300$ hard earned money tied up somewhere with no response from the business! I am 2 clicks from being finished with...

Hi, Alex I've double/triple/quadruple checked those connections. Since everything appears to work correctly now I even ran the Wizard once again...

Check again the Rx to OSD connections. Make sure elevator out goes to RVOSD elevator in and Aileron out goes to aileron in. Have seem this problem...

Well, I don't understand how I could mess that up. I went through the wizard several times and just followed the on-screen directions. I assumed that...

Servo directions should be properly set after you run the wizard... If you do it properly.

Alex, Thanks for the reply. I actually did have everything plugged in and connected correctly and when not in FBW mode everything responded...

Still "processing"... Order was placed on Monday. Emails sent to RangeVideo were unanswered, so were the phone calls... How do I get in touch...

The only thing you have to try is here: http://www.rangevideo.com/forum/showthread.php?1530-RVOSD-G5-instructions-%28work-in-progress-%29 Make...

I understand your premise...I've tried just about everything at this time. The Tx setup is conventional (normal ailerons) as per setup instructions....

Vova told me that he found a baro damaged on one of them, the others had a damaged inductor. Hard to know how this happened.

I had the same issue when setting up RVOSD on my zephyr. Its hard to tell exactly what your problem is without seeing all your setting, but there...

Hi elliott000, i solved the problem by installing the new firmware on my Turnigy (erx9). I also set as "ppm frame rate" 22.0. I installed the v...

My point is when it is already in RTH mode and battery drops low while in RTH mode. Obviously, with control link established there would be no low...

I have the same numbers. Ive found it can depend on local interference even my cell fone .... try another area and you might notice a change, my...

well its good to atleast have a timeframe then, ty. Im just a state away, so hopefully it wont take longer than 4 weeks :( such nice weather to fly...

RV repair service is excellent. They can be a bit hit or miss with responding to enquiries, but I have sent my RVOSDs back quite a few times for...

Its been 2 weeks since I sent it away, and 3 emails without any response. Anyone know how to get in touch with them or how long I should be waiting?...

That is normal. Check the manual for adjustments. It can be changed

Hi Alex, Just wondering if you have heard from Vova what the problem was with my 3 new faulty osd's? All I got was an email from him saying...

I recommend you to use a PAL setup if your camera and monitor/goggles can handle it. OSD looks much better and there is better resolution. It will...

Thank you, Alex - I'll definitely take your word for it and that does make sense. What about the oval display? Also, it there a recommendation to use...

It will display properly when the plane is moving. Basically GPS heading depends on having enough speed in order to calculate the direction vector.

+1, of course ;)