Activity Stream

Filter
Sort By Time Show
Recent Recent Popular Popular Anytime Anytime Last 7 Days Last 7 Days Last 30 Days Last 30 Days All All Photos Photos Forum Forums
  • HF_ATL's Avatar
    Yesterday, 10:51 AM
    You must learn and start slowly, it's not something you wake up and say hey today I want to go 30km, it not works that way sorry. You can pay but...
    1 replies | 24 view(s)
  • valeravl's Avatar
    01-27-2015, 11:11 PM
    Hi, i need to build longrange FPV. It's a volunteer project and i'm looking for and expert in this area. I'm going to use RV Jet as a plane. But...
    1 replies | 24 view(s)
  • hi-xi's Avatar
    01-27-2015, 08:54 PM
    hi-xi replied to a thread Soporte, en Español in RVOSD/ FPV
    Buenas noches. Llevaba ya tiempo fijándome en el RVOSD como una alternativa solvente para instalar en mis aviones y por fin ha surgido la...
    1894 replies | 269412 view(s)
  • bovick's Avatar
    01-27-2015, 04:33 PM
    bovick replied to a thread RVGS, instructions... in RVOSD/ FPV
    Any word on differences in new RVGS vs old? Also likely availability date? I really hope the home setting procedure is better and there is a 5...
    774 replies | 75011 view(s)
  • edkwok's Avatar
    01-27-2015, 02:36 PM
    Great!! Thats a fair price. Hope to see it available soon.... REALLY hate to have the reflection of sunlight from behind :(
    7 replies | 137 view(s)
  • ommadawn's Avatar
    01-27-2015, 08:34 AM
    Bargain! Rob38 is going to hate you!
    7 replies | 137 view(s)
  • reznikvova's Avatar
    01-27-2015, 07:32 AM
    Aiming for around 20- 30 USD for the complete mask.
    7 replies | 137 view(s)
  • Alex Villa's Avatar
    01-26-2015, 04:02 PM
    You did set it correctly, RVOSD will look for FS point on throttle. But also if CPPM signal is lost will enter RTH. So you can leave it as is.
    27 replies | 938 view(s)
  • viper1's Avatar
    01-25-2015, 02:49 PM
    Thanks Alex, but I'm confused now, did I set it correctly (see question in previous post) or do I need to change it to glitch counter ?
    27 replies | 938 view(s)
  • Alex Villa's Avatar
    01-25-2015, 01:59 PM
    It sets Glitch counter when the CPPM signal is lost(or corrupted) after you turn the RC Tx off. BTW Vova tested the firmware, and it is working....
    27 replies | 938 view(s)
  • Funky Diver's Avatar
    01-24-2015, 12:55 AM
    I'm planning to do the same with mine now I have my RVOSD sorted. I take it you just take the signal out from the RVGS with the two power wires...
    774 replies | 75011 view(s)
  • Funky Diver's Avatar
    01-23-2015, 11:57 PM
    Funky Diver replied to a thread Firmware Rollback in RVOSD/ FPV
    I would like to say a big thank you to Vova, you went beyond anything I'd expect from a larger company, and yet have exceeded my expectations triple...
    21 replies | 1277 view(s)
  • viper1's Avatar
    01-22-2015, 08:30 AM
    Thanks for the code Alex. I went through the set-up and she looks ready to go. By your description I thought you replaced the Amp display with...
    27 replies | 938 view(s)
  • JAVMAC's Avatar
    01-22-2015, 07:58 AM
    JAVMAC replied to a thread Soporte, en Español in RVOSD/ FPV
    Vale ya está solucionado. Al desmontar el sensor del avión me he dado cuenta de que había soldado los conectores de la batería donde el ESC y...
    1894 replies | 269412 view(s)
  • Alex Villa's Avatar
    01-21-2015, 10:20 PM
    Alex Villa replied to a thread Soporte, en Español in RVOSD/ FPV
    El sensor venia con los connectores soldados? Puedes poner una foto?
    1894 replies | 269412 view(s)
  • JAVMAC's Avatar
    01-21-2015, 10:15 PM
    JAVMAC replied to a thread Soporte, en Español in RVOSD/ FPV
    Haciéndolo así arranca con un valor más lógico de unos 0.6 A, el problema es que al mover los servos o dar motor el valor en vez de subir baja a 0.5...
    1894 replies | 269412 view(s)
  • Alex Villa's Avatar
    01-21-2015, 09:21 PM
    Alex Villa replied to a thread Soporte, en Español in RVOSD/ FPV
    Solamente asegurate de que el sensor de corriente este alimentado y conectado cuando conectes la bateria auxiliar. Asi el OSD podra configurar el...
    1894 replies | 269412 view(s)
  • JAVMAC's Avatar
    01-21-2015, 08:29 PM
    JAVMAC replied to a thread Soporte, en Español in RVOSD/ FPV
    Me temo que no sea eso, tengo el jumper en "main battery disable" por lo que el osd se alimenta por la auxiliar y por tanto no arranca hasta que no...
    1894 replies | 269412 view(s)
  • Alex Villa's Avatar
    01-21-2015, 07:47 PM
    Alex Villa replied to a thread Soporte, en Español in RVOSD/ FPV
    Ese es el problema, la bateria principal debe ser conectada primero, esperas 30 segundos, y despues la auxiliar. La razon para esto es que durante...
    1894 replies | 269412 view(s)
  • JAVMAC's Avatar
    01-21-2015, 07:33 PM
    JAVMAC replied to a thread Soporte, en Español in RVOSD/ FPV
    Ya está actualizado y desbloqueado pero por desgracia sigo teniendo problemas con el sensor de corriente. Al conectarlo me aparecen unos 12A de...
    1894 replies | 269412 view(s)
  • Alex Villa's Avatar
    01-21-2015, 05:53 PM
    Alex Villa replied to a thread Setup Question... in RVOSD/ FPV
    Yes, there is hidden parameters that can only be set during the wizard. Always run the wizzard after flashing new firmware.
    1 replies | 43 view(s)
  • ommadawn's Avatar
    01-21-2015, 11:16 AM
    ommadawn replied to a thread RVGS, instructions... in RVOSD/ FPV
    I power my RVGS off a 3s lipo. In an emergency can I run it off a 4s for a short while, or will I risk blowing it up (again) I use a separate UBEC...
    774 replies | 75011 view(s)
  • viper1's Avatar
    01-21-2015, 09:38 AM
    viper1 started a thread Setup Question... in RVOSD/ FPV
    My question is if there are any parameters stored in RVOSD when running the RC Wizard that are NOT normally accessible in the menu? In other...
    1 replies | 43 view(s)
  • viper1's Avatar
    01-21-2015, 08:29 AM
    Thank you for your great work again Alex, I have flashed this firmware, unlock request sent to your PM inbox. We have a long weekend coming up...
    27 replies | 938 view(s)
  • Alex Villa's Avatar
    01-21-2015, 12:45 AM
    Ok, I reworked the code. This version should make the cruise speed active. Changes are: -Power consumption of motor displayed in watts also....
    27 replies | 938 view(s)
  • JAVMAC's Avatar
    01-20-2015, 06:57 PM
    JAVMAC replied to a thread Soporte, en Español in RVOSD/ FPV
    Ya está hecho Alex, tienes un MP con el ID para el código de desbloqueo. Saludos.
    1894 replies | 269412 view(s)
  • Alex Villa's Avatar
    01-20-2015, 02:01 AM
    Post #119 http://www.rangevideo.com/forum/showthread.php?2242-RVGS-instructions&p=22716&highlight=pinout#post22716
    4 replies | 86 view(s)
  • p521us's Avatar
    01-20-2015, 01:21 AM
    So everything works great, as long as I pull the plug out part of the way.... Should I be using a cable with 1, 2, or 3 rings around the pin? Im...
    4 replies | 86 view(s)
  • ommadawn's Avatar
    01-17-2015, 11:49 AM
    Not sure about the pinout on Immersion, but I found with the Lawmate VRX, the Audio and Video ring sections on the plug pin were transposed from the...
    4 replies | 86 view(s)
More Activity