Search:

ordering today :)

I was afraid of that. Only way is through the Pickit 2, and not through the usb port on the side, right?
Thanks,
matt

Ive never had this problem before with any of my 4 RVOSD5's.

The wing sat in my house all winter and I went for a flight today, the gyros/artificial horizon now take almost 10 seconds to catch up...

Looks like I solved it :)

I setup a black and white piece of paper in front of the camera to simulate the contrast and sure enough, it started going crazy in the middle of the screen. With a...

ok, the cover is off the lawmate and I think I have found the video adjustment pot. Please excuse my newbness with regards to adjusting these, but do you ahve any advice besides just turning it...

Once again, thanks for your prompt reply and assistance Alex. Ill experiment with a few resistors.:cool:

I just finished my new rig and maidened it yesterday. Im getting some video sideways distortion when the plane/osd are level. When I tilt up or down, the shift stops. But as soon as I level the plane...

Had the servo lead wrong on the accessory channel.
Fixed.
thanks for the tip.

Thanks for the quick response Alex! Ill check that later and report back.
Matt

Ive installed 5 RVOSD's, so Im a little perplexed that this is happening.

New install on a brand new unit in a skywalker. I turn it on and go to the wizard. Warning that no receiver detected, yet...

I would be more concerned about that giant black blob hovering on your screen... :)

Have you flown a Queen Bee before. My friend has one and even with some support, it flapped in the air like a bird. If its not too late, you could add a few carbon ribbons span-wide on top and...

Pascal, I finally got mine working, was the USB driver.
I have a suggestion. Your sequencer is great for aerial mapping with the RVOSD5. it would be perfect to have an option along the route to...

Not sure if this is the right thread...

Will the EagleTree airspeed sensor work with the newest RVOSD5? Since I have one laying around, I would like to use it instead of buying the MPXV7002DP...

Used this GS yesterday for the first time. Worked like a charm and very useful info. Is there a way to display your entire track without watching the replay file from the beginning?

Also, the...

with the ability to pan/tilt a camera and stabilize it now, whats the chance on using the GPS data to fix the camera on a target. Ardupilot mega now does this, and so does mikrokopter to an extent.
...

+1 from ommadawn. you need to push the connector all the way in, then slowly pull it out a few millimeters until the signal shows up. I put a small rubber o-ring around the connector so I can push it...

Thanks! That 2nd photo shows it nicely.
matt

Can someone point me to a diagram, picture, or instructions on where to solder the pan/tilt servo leads to the RVOSD5 please?
Thanks,
matt

Alex, what specific option at the top is that called?

ive pressed every one and they dont allow me to edit the parameters.

also, if i press read configuration to osd, i get an error reading...

having trouble with this. it found the RVOSD but all the fields are greyed out and I cant adjust anything. This is a new RVOSD5 just out the box that arrived the other day.

such a gorgeous, sparse flying location. You are very lucky, trust me.

Careful, this link might have a virus ;)
kidding.

http://www.amazon.com/StarTech-SVID2USB2-S-Video-Composite-Capture/dp/B000O5RIWO

Squawk: yes, you preload the area you are going to fly (which for our models isnt a problem) thus eliminating the need for an internet connection. All you do is zoom into the area you are flying and...

Ok, I got the video to work :)
Im using a USB video capture cable with one end plugged into the output of the RVGS and the other to a USB port on the laptop. The other USB cable gets connected as...