Search:

Here are some picture of my setup

173517361737

I set my tracker up. After home is set I walk my plane out about 50ft. Go to my tracker and do the offset thing. I then turn my tracker to the plane. Now I fly. Works fine for me.

I do wish the...

What makes it so difficult to desolder connectors on the new current sensor and replace them with deans?

No idea.

On my 9z the trainer switch is an assignable switch.

As in using a 3 pos to change screens and to activate autopilot like usual... Then use the trainer switch to cycle autopilot functions...

I understand what you are saying now. You are using the y cable to connect the aux channel to the osd and also using it for power.

I thought you were using the y cable just for the purpose of...

You don't actually need the Y... Try it. If you are powering the osd 5v rail with the ubec and you have a servo wire going to the rx, you are powering the rx...

Love the new additions.

You can get rid of the y cable. If the ubec is plugged in the rx or the osd you have power for the rc stuff. Once you have it hooked up, go in your menu and make sure you have you rc control turned...

I'll call you...

Yes.. RoberFPV is R. Montiel... The 71km there and back record holder... ;)

http://www.youtube.com/watch?v=aq0y3PfC7NQ&feature=youtube_gdata_player

I'm sorry I mean continuious turning so the antenna doesn't have to "flip sides"...

It just feels unsecure. I'm thinking I might go with a servo city setup.

Alex, will the tracker work with a 360 pan system?

Not that kind of lag.

Went out and played with my RVGS1 I'm very happy. I'm not happy with the mechanical side of the tracker. I'm using the eagle tree tracker that rmrc sells and it just doesn't seem up to par. The only...

I mean male to male mini rca. I could cut the wire, re solder, and heat shirnk it.

Well that sucks I was hoping to buy some 6"-1' cables to go straight from my lawmate to my RVGS1 to clean it up a bit.

Did you not order it with the PICit2 device?

I actually just ordered/found these 12v BECs. I also have not recieved them yet. I use an 800mah lipo on my plane for the 12v but i either forget to unplug it or forget it at home when I go fly.

Welcome to RVOSD D-Man.

1. Yes if you are using a BEC. The OSD servo rail is not power. You will either 1) keep the esc red wire in and let that power your servos and rx or 2) run a BEC and plug...

Show us some video. That usually helps.

Unplug the the motor wires or take the prop off. plug in power, Once osd is set, go full throttle and then increase the throttle trim til the osd screen says return to home. Set you're fail safe. now...

And don't forget to save configuration in the osd menu to save the settings.