Search:

I did erased it, I do manage the forum, but there is very little I can do about orders. That has to be handled via support@rangevideo.com and they are always handled positively to the customer. You...

Like Ommadawn says, is very hard to get the current sensor to fail.

De que OSD estamos hablando? Espero sinceramente que no sea el mismo que ya tratamos mas arriba, esta sería la quinta clave que pides para el mismo y ya te explique el firmware que tenías que...

Works fine on my PC machine, Windows7 64 and latest Mozilla firefox.

"Rx not detected" significa que el OSD no ha detectado señal desde el Rx al inicio. O que el Rx estaba mandando señal de failsafe desde el inicio(asegurate de tener prendida la emisora antes de...

Check again the Rx to OSD connections. Make sure elevator out goes to RVOSD elevator in and Aileron out goes to aileron in. Have seem this problem before, a guy had this reversed when he tried to...

Servo directions should be properly set after you run the wizard... If you do it properly.

The only thing you have to try is here: http://www.rangevideo.com/forum/showthread.php?1530-RVOSD-G5-instructions-%28work-in-progress-%29

Make sure your RX elevator output goes to RVOSD elevator...

Vova told me that he found a baro damaged on one of them, the others had a damaged inductor. Hard to know how this happened.

I recommend you to use a PAL setup if your camera and monitor/goggles can handle it. OSD looks much better and there is better resolution. It will fix the "Oval" radar issue.
This depends on your RC...

It will display properly when the plane is moving. Basically GPS heading depends on having enough speed in order to calculate the direction vector.

If the battery were 100% efficient you could have to put the same amps you put out. On the real world batteries are less efficiency, some energy is wasted on heat and other causes.

Part is this: http://www.digikey.com/product-detail/en/744066150/732-1077-2-ND/1638482?cur=USD

About the cause of the crash... I think it was BEC failure. No power to the servos so no manual or...

You better change the servo buffer. It is cheap and does not work to take the risk.

All I can say is that RVOSD software does not crash.
I programmed it on assembly language, thus there is a very close control of all processes. Still the software does have "trap" handling routines...

You can't see anything wrong on it, but trust me, the problem is the cable. To be more precise, the problem is where the connector pins are clamped to the cable.

El problema puede ser que este firmware lo hice con un decodificador distinto. Prueba: GJ16BL

...tienes que poner el "call sign" a ON...

Your GPS cable or connectors are damaged, need to replace the cable.

Que decirte... Podría empezar por un OSD que compraste en Rangevideo y ahora no recuerdo porque razón decías tener un problema con el. Personalmente te envié una placa de reemplazo pensando que tal...

Código de desbloqueo es: BC8RLU

Tacho, puedes eliminar la ferrita y poner un puente, no debería tener ninguna consecuencia. Hay otros componentes para el filtraje de RF, la ferrita se puede considerar "sobre-ingeniería" para casos...

No! no puedes conectar el GPS de esa manera. No hay ninguna manera "fácil" de hacerlo. Tiene que ser en el conector:
http://www.rangevideo.com/forum/attachment.php?attachmentid=2273&d=1366836735

No, they didn't reversed by themselves. That just can't happen.

This seems like a problem with the camera or camera to OSD connector.