Search:

hi

I noticed rv is selling folding prop blades .

does anyone have the dimentions ?

im interested in offset , shoulder width and hole size , id like to try to use this on a stock radian...

ntsc , dx 201 , 800 mw tx with a home made ground plane (or any antenna )

I turned down the video output on the camera , it helped a little.

inside the tx , theres an adjustment pot -- does...

l-9 you can jump , yes the part is missing , but can be bypassed , solder a thin wire over it.

It also looks like some pins are bent inside the usb port = check for shorts ( pins touching each...

so I got this crazy idea ( again ) , from the looks of it I could easily cause the electronics on my " beater " plane to become waterproof ( or close enough ).

besides the outrunner motor that I...

if you could , put the filter on the vtx and the patch on the rx , place the patch near the ground about 6 to 10 inches hight , 50 degree angle ( can be done by "eye") --make sure you stay out in...

with no other antennas besides what you get , the distance you get seems right.
I bet your tx is " notably hot "

same system , using a patch on the receiver , might get you a 1/2 mile or so.
...

hi
I think I cooked my rvosd after I snapped the gps connector off . I tried a pinout from a picture and im not sure if the pic is right , or if I have the wrong modle rvosd , or if I cooked the...

awesome , that's it.

ribbon cable sounds like a good idea.
maybe make a break away from cut down ide connectors .
the flat cable should pin down nicely - ( if you don't rip the traces out.)
...

ok so my gps "plug" got loose on my osd board , I went to verify this and ripped it off completely , and yes it pulled off a trace .


im now looking for an alternate location to connect my red...

hi
I have the 800 mw 910 tx , its getting old ( I think )
what does it look like when a vtx goes bad ?
http://www.youtube.com/watch?v=LdF35odo_xU&feature=youtu.be


I tried 3 recievers , 3...

trainer options should work with your radios (tx) through the rvod - the rvosd will only see 1 reciever , the tx decides whos driving.
if the trainer does not work with out the rvosd , it very...

I was mad for turning my back on the plane while I'd sort myself out and get comfortable in my seat ;D


heh , i had an issue with a park ranger who said i couldnt fly an rc plane in the park...

So ,

whats size motor and esc might be recomended ? , how many batteries can i jam inside ?


after fpv - ing , boats and trucks and airplanes , these seem like the 2 questions...

i use both
i have the " close " antennas fixed ( 2 patches ) on the oracle , then i have a home made yagi on the antenna traker.

it gets me away from having to have a more compliated drive...

that was it !

i reset it to the lowest setting , and now it works

thank you
merry xmas
Brian

needles offset ?2088

i had this across 3 versions ? --- is there a way to fix it?
heading , alt , horizion , speed -- all off just a little - i tried un install , ect -- nothing

great stuff...

i use aileron output to my rudder . no problem .

i think ( with my airplane ( parkzone radian ) ) - that the ap is less jerky , more relaxed --on the rudder.

it might be due to the flex in...

or i can just use the second rssi for my main ? if so is there any pinout change .

and
i was going to ask if i could use this for 2 current sensor (s) .

thanx !!

im sorry

it absolute g5 70 amp

http://www.youtube.com/watch?v=rz8X5m3PwyQ&feature=youtu.be

at 1:06 starts airplane , sorry for lousey edit .

or down ?

hi
my current sensor reading counts down ( in negitive numbers )- ( is that up ?).

i have a 40 amp sensor , 5000 mah battery . the battery capacity is set in the osd menu as 5000 (...

thanx again !
that explains everything !

is there an input side and output side , or will it measure in both directions ?

thanx

if it ever becomes possible , ill be the first victim .

id still settle for a way to mark my waypoint in flight , and be able to offload it on the ground .

waypoint avoidance ( or avoid point...

could we at some point , be able to upload to rvosd , a waypoint - but it would be an avoid radius way point ?

like the plane goes around a pre set way point ? or avoid point ? or no fly point ?...

I have figured out a way to use online radar images from local tower controllers and also flight info from sites online to determine what traffic is in the area. Now if I can overlay the info somehow...